You will need two lint free, non-abrasive cloths for this procedure. 

  1. Turn off any connected computers.
  2. Turn the display off. 
  3. Wipe all surfaces with the first dry lint-free, non-abrasive cloth to remove dust and debris.
  4. Gently spray a small amount of the water or cleaning solution on the second cloth.
    Note: Do not oversaturate the cloth to the point it is dripping.
  5. Wipe the screen with the dampened cloth.
  6. After wiping the screen, wipe off the remaining SMART Board surfaces that one can normally touch, such as the frame, pens, and other accessories.

CAUTION

  • Do not use permanent or dry-erase markers on the screen. If dry-erase markers are used on the screen, remove the ink as soon as possible with a lint-free, non abrasive cloth.
  • Do not rub the screen with dense or rough material.
  • Do not apply pressure to the screen.
  • Do not use cleaning solutions or glass cleaners on the screen except as noted previous, because they can damage or discolor the screen.
  • Do not use pre-moistened wipes.
  • Refer to the cleanser’s packaging for safe handling instructions

 

70-90% isopropyl alcohol (Accessories to clean the Smart Board)

Isopropyl alcohol comes pre diluted and no mixing is required. For concentrations above 90%, dilute accordingly with distilled water.
 

Recommend using a spray bottle for applying the solution to the cloth to avoid oversaturating it.
Note: Test a small, inconspicuous area before you clean the entire surface.